Cowling
Cowling (pg 2) Cowling (pg 3) Cowling (pg 4) Cowling (pg 5)

 

 

RV6A Home
Up
Flight Adventures!
Flight Testing
First Flight!
WA to CA move
Finishing Stages
Panel & Electrical
Fuselage
Wings
Empennage
RV-6A Paint Job
2013 Pictures

 

 

 

 

 

Aviation Links:

Van's Aircraft

Van'sAirforce.net

AirNav.com

AeroSportPower

Dynon Avionics

AeroElectric

Connection

Stark Avionics

 

 

RV-6A Home Finishing Stages Firewall Forward Fuselage Panel & Electrical Wings Empennage

 

Back Next

Cowling:   pg 1   |  pg 2  |  pg 3  |  pg 4  |  pg 5

 

These pictures show the initial fitting of the top cowling, which I did per Van's plans.  It came out pretty well in the end, at least as far as I could tell at the time.  We'll see how it looks when it's done and flying!!

 

I bolted the spinner backplate to the starter ring gear and clamped the cowl to the spinner back plate with wood spacer blocks in place to achieve the desired gap between the rear of the spinner and the front of the cowl:

 

Here's a better look at the spinner to cowl gap and the spacer blocks clamped in place:

 

Per the Van's construction manual advice, I marked a line on the forward top skin that was 2" back from where I wanted the cowling trimmed to for a nice fit.  Here you can see the cut line marked on the cowl top half after measuring back from that 2" line:

 

Side view of same cut line:

 

And here's the cut line marked on the right side of the cowl top:

 

View of the spinner to cowl gap from right side:

 

Cowling:   pg 1   |  pg 2  |  pg 3  |  pg 4  |  pg 5

Back Next
 
 

  This page was last updated on 12/18/11.

 

Click here for questions or feedback. 

Copyright 2007.  All rights reserved.  Chris Hand, chris@ckhand.com